Price of 7X7 stainless steel wire rope

How to use the wire rope:
1. When the wire rope is wound, the number of rope clips used should be doubled according to the number in Table 7.
2. The tightness of the rope clamp must be appropriate. Tighten the rope clamp and flatten the wire rope to 2/3 of the rope diameter.
3. The arrangement of the rope clamps should be regular, and the curved part of the U-bolt should be located at the end of the strand side of the wire rope, so that the saddle
contact with the main rope.
4. After the Stainless Steel Clip is clamped, it is best to make a mark between the two clips, or before the last rope clamp
The tail rope should be longer, and observe whether the wire rope slips after being stressed.
5. The splicing length of Stainless Rope is generally 20 to 30 times the diameter of the rope, and a larger multiple should be used for thicker ropes.
6. No extended wire rope shall be used on the lifting block, otherwise the following requirements shall be met:
a. The tension test proves that the rope head is connected reliably; b. The rope head can pass through the pulley groove safely and smoothly.
7. When cutting the wire rope, in order to avoid loosening of the rope head, the two ends of the cut should be fastened with thin iron wires in advance, and immediately after cutting
Fuses each wire at the break.
8. 316 Steel Steel Rope shall not be in contact with welding wire or other wires, and protective measures shall be taken to prevent possible collisions.
9 When steel wire ropes cross overhead transmission lines, solid bamboo (wooden) cable trays shall be installed;
When working on one side or below, the safe distance between the wire rope and the overhead transmission line should meet the requirements in Table 3.
10. When the crawler vehicle crushes the Steel Wire Rope, effective protective measures should be taken for the steel wire rope, and direct compression is not allowed.
on the wire rope.
11. Inox Wire Rope must not directly contact the edges and corners of the workpiece or structure, otherwise protective measures should be taken.
12. The wire rope shall not be bent or twisted into an acute angle, nor shall it be clamped or flattened. when a wire rope is found
If there are broken strands, looseness, serious kinks, etc., they should be stopped and scrapped.
13. The wire rope should be checked and repaired frequently during use. In case of any damage, corrosion or disconnection
According to the provisions of Table 4 and Table 5, reduce the use capacity, and cut off the broken steel wire from the root, so as not to scratch the adjacent steel wire.

Standard :  EN12385-4 or DIN3055

Packing Term :　Plastic Spool ,  Wood reel or Coil 

Length Per Reel :  50m, 100m , 150M, 250M , 500m ,  1000m,  2000m ,  5000m